(800) 853-2651
SHOP NOW

IH 3PH WILL NOT DROP DOWN

R

Ron Bailey

Member
Hello,
I have a IH 1486 ,
The 3PH will not drop down. It was sitting about 1 month. I started it up the 3 PH lifted up but will not go back down.
I have checked to make sure the lever was pushing the lever correctly and it is.

Any one have a clue on what I might can check.

Thanks
Ron
 
I've got a smaller, older IH that has a little valve you move to make the arms stay up or lower slow. Mine is just below the front of the seat on the left side.

Dave
 
we have a 1066 the levers down in trans jumped out of place. part of the torsion system my younger brother figured out what was wrong with the 10. went thur the pto hole
 
OK,, I will look to see if Mine has that.

Once the tractor is off, the 3PTH will will slowly drift down, But once I start the tractor it lift back up. I can move the hand lever back and forth and it does not move at all..


Thanks For your help
 
The 3 pt has a torque lever just behind the top link plate. Remove the plate, you can feel or see a lever from the rockshaft plate. It should be behind the lever coming from the lower shaft at the bottom of the mainframe. I put a washer on the Rh outside of the lower lever that will keep the upper lever in place. Should correct the situation.
 

Move the draft lever to the middle. If you have it all the way in one direction or the other, can't remember which, the 3pt will go all the way up and will not come down no matter what position the lever is in.
 
Hey Ron sorry so long getting back to you have been cutting beans. The drop check valva is behind a plate on the front of the seat tower if I remember correctly. It may be stuck there is a big locknut on it loosen that and take the valve out then take it apart there is a spring inside it with a check ball below it. If that doesnt work ask further.
 
You must log in or register to reply here.

Similar threads

K
MF 265 3ph not raising
Replies
5
Views
300
keljan11
K
J
Ih 606 not starting
Replies
8
Views
343
Janicholson
Janicholson
A
IH 1086 PTO drive bear replacement
Replies
2
Views
99
Ayden
A
T
Weak PTO on IH 300 Utility
Replies
4
Views
258
MARK ROBKE
M
J
Cockshutt 550 3PH not working
Replies
13
Views
746
JohnnyUnknown
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top