Need help with 8n Govenor on Funk Conversion

paynet · Aug 21, 2017

I could sure use some help. I need to rebuild my govenor on my *N Funk Conversion and I'm not sure how to get the fron section seperated from the body to get to the screw that holds the internal assembly in the case. It looks like I need to drive the shaft out of the belt pully that replaces the gear, but I don't want to take a chance driving something that I should not. If anyone has had experence taking the front end that came in the Funk Conversion off of the 8N govenor I would sure appreciate the help.

Terry

John P. · Aug 22, 2017

You might get a better response if you post this over on the 8N forum.

paynet · Aug 24, 2017

(quoted from post at 17:18:37 08/22/17) You might get a better response if you post this over on the 8N forum.

Thanks! I got it apart just took a hammer and punch to it. As far as responding on the 8N forum I'm giving up on this as it took me 30 minutes to figure out to make a post and now I'm not sure if this reply is going to go as it seem that this site is not very user friendly.

Need help with 8n Govenor on Funk Conversion

paynet

New User

John P.

Member

paynet

New User

Similar threads