(800) 853-2651
SHOP NOW

Wiring diagram

B

Bill from Scotland

Member
Looking for a simple wiring diagram to allow me to create flashers (turn indicators) for my MF and trailer. I will have four light units, two on the tractor and two on the trailer of which the ones on the left will show other driver when I intent turning left the right will work the same. I guess I need some sort of switch, flasher unit, wires, fuse and connections. Any ideas welcome.
Thanks
Bill
 
All you have to do is go to a junkyard, or auto parts store, and pick up a 552 heavy duty flasher unit, and put the hot wire on the appropriate terminal, and the wire for your lights on the other. I don't recall, but I think you won't mess up the flasher, if you connect it wrong, just won't function.
 
Whoops, misread the post. To make turn signals, get one of the old style turn signal units, like the old jeeps have, mounts on the steering column, and has a little wheel, that runs against the steering shaft, to cancel the signals. If you don't feel like cutting a hole in the column guard, don't, and just remember to turn it off, manually.
 
its really very simple...starting from your power source run a 14 gauge stranded wire to a fuse holder...7.5 amp should be plenty...from the fuse run more 14 gauge to either spade on a heavy duty 2 spade flasher unit...from there run more 14 gauge to the center post of a center off [on-off-on] 3 pole toggle switch...run 14 gauge from each side of switch to the left pair of lights or the right side...make sure lights are grounded...thats it.
 
Bought an old boat and trailer, with no lights- thought about going the wireless route ($290), but bought a tail light wiring kit ($30) instead. Can't remember perzactly why I went that route. . . LOL
 
Hey Bill,
the setup on german tractors is pretty simple, then wire in a trailer plug and a prewired set for the trailer can be had for 20 bucks. If you'd like, I can send you a wiring diagram. Just shoot me an email at

[email protected]

Dave
 
You must log in or register to reply here.

Similar threads

B
Starter Wiring Diagram
Replies
1
Views
602
Jim.ME
J
K
222 wiring diagram
Replies
2
Views
837
karl h
K
D
Trying to understand cab/lights wiring connection to light switch on farmall 826 diesel
Replies
2
Views
279
used red MN
U
B
MF 40 Neutral Safety Switch and wiring help
Replies
4
Views
438
Jim.ME
J
T
How do I drain the radiator and engine block?
Replies
6
Views
539
caterpillar guy
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top