(800) 853-2651
SHOP NOW

That's the Dumbest Thing I Have Done Lately...

S

Super-H-Mike

Member
Late last night I was working on a Saturn, the job was to replace the bad P.S. pump with a used one. Keep in mind this is a tight , tough job. I pulled the old one off and compared it to the "new " one, looked good. So , I am halfway through the install when something didn't look right to me.... Sure enough, I was putting in the SAME one I had just removed ! Dang , felt like an idiot ! I guess it was a long day and my mind was mushy ! lol
 
LOL
Yep,I think we all of guilty of this
We just don't put it in writing !LOL
my normal problem is pulling a dull chain off the chainsaw and put the dull one on again instead of sharp chain.
Ive done the same thing on tractor parts!!!!
Not good
 
looking for something can't find it. go to store buy what i'm needing get home say that looks like a good place to keep it and find i already have 2 more there.
must not have been a good after all.
 
I did almost the same thing today. I replaced the blades on my Woods 6 ft. Brush Bull. Took off old one and put on one one then the stump jumper turned and I remover the new one rather than removing the old dull one.
 
Few years ago took the dual off for plowing.

Had the plow on before noticing I took the wrong dual off.

Doh.

Paul
 
hate it when that happens,,, yesterday I was loading "poo" got done stepped out of the 580 and seen a chunk of iron in the "poo" grabbed it threw it in the junk pile I have been adding to on this job then climbed back in the 580 only to see I had already loaded the spreader! I had a good laugh at myself as I was getting out again
cnt
 
You must log in or register to reply here.

Similar threads

jd2cyl1943
what I have been doing lately
Replies
6
Views
381
Richard G.
R
D
Roofing question - limited access to drive nails
2
Replies
25
Views
1K
dhermesc
D
jd2cyl1943
Here's the story of my JD Bs restoration up to this poi
2
Replies
26
Views
2K
jd2cyl1943
jd2cyl1943
C
MF Power Steering
Replies
1
Views
640
Mduncan60
M
F
Well I did have it running for awhile
Replies
8
Views
1K
fixerupper
F
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top