Help with Carb Bowl

jd2cyl1943 · Dec 9, 2022

I can't get the brass screws and bolt out of my DLT 7 bowl. Any advice?

rustred · Dec 9, 2022

is that for the throttle plates ?

jd2cyl1943 · Dec 9, 2022

No the ones for the float.

rustred · Dec 9, 2022

there is only one screw for the float. you need a big screwdriver to totally fill the slot and down pressure while turning it or trying to.
do not slip the screwdriver or the brass will break off. i have had tight ones but they come out.

jd2cyl1943 · Dec 9, 2022

As I said I have one on each side.

Mark Poss · Dec 9, 2022

Heat until they turn green and let cool. If they dont come out reheat and try again.

rustred · Dec 9, 2022

post that in a picture. i have never saw a float in them carbs with two screws. its a screw with a pivot pin that the float pivots on.

Rodney51Cub · Dec 9, 2022

I agree with some heat.

Picture for rustred
https://partscatalog.deere.com/jdrc/sidebyside/equipment/76777/referrer/navigation/pgId/99396

Item # 25 two per assembly.

rustred · Dec 10, 2022

There u go. Nothing saying u need to remove them both.
Get a good screwdriver and eat ur spinach and one will
come out. BUT use a small punch the same size as the
screw head and give it a love tap first.

Lynerd · Dec 10, 2022

jd2cyl1943 Clamp bowl in vise and use an Impact screwdriver. Lynn
https://www.amazon.com/TEKTON-2905-8-Inch-Manual-7-Piece/dp/B000NPPATS

Help with Carb Bowl

jd2cyl1943

Member

rustred

Well-known Member

jd2cyl1943

Member

rustred

Well-known Member

jd2cyl1943

Member

Mark Poss

Well-known Member

rustred

Well-known Member

Rodney51Cub

Member

rustred

Well-known Member

Lynerd

Member

Similar threads