Farmall & IHC Tractors Discussion Board |
Re: shimming f-20 rod bearings
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dale13 on April 21, 2001 at 04:34:46 from (207.49.223.178):
In Reply to: shimming f-20 rod bearings posted by Shawn on April 19, 2001 at 19:25:08:
It's very unlikely that you will have to put shims in. Crank gets worn and the clearances get sloppy,you take shims out that were there since tractor was new.Take the two access covers off the side of the block,you can do all work thru these.Take all spark plugs out,makes it easier to turn over and safer. Take one shim out and reinstall cap,turn motor over.Do this process till you feel resistance then put one shim back in. Torque is tight,spec unknown.If you were going to work her hard all season you would check these each spring.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|