Farmall & IHC Tractors Discussion Board |
Re: Mr. Haney and the snowball effect
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on May 25, 2001 at 14:57:15 from (216.46.140.186):
In Reply to: Mr. Haney and the snowball effect posted by William on May 25, 2001 at 09:09:15:
William, I just did the H brakes and seals. The new seals are less than half the width of the old ones, but the technology of them makes them far better than the old wide felt ones. My dealer told me to install them flush to the tractor only. Make sure that the collar on the drum is clean and rust free. I bought an old H that had been outside for many years and the slight little rust spots on the collar were enough to chew up the old seal. I cleaned them with fine emery cloth. You will find another advantage to the new seal. The collar may be marked from where the old seal ran on it, the new seal sits further out and runs on a different spot on the drum collar,thus no leakage and a good seal. Give me a shout if you need any info. My dealer was good enought to run off a copy of the assembly and a copy of all the parts and part numbers. Good luck from Mike in Exeter ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|