Farmall & IHC Tractors Discussion Board |
Farmall C skipping a beat
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on July 02, 2001 at 04:09:53 from (129.37.117.100):
A while back, I posted a comment about my Farmall C skipping or missing. It ran good, but would hesitate or miss. I regapped the points which were set too wide and that did not help much. It had spark suppression type plug wires on it. I replaced those with copper wires. Problem Solved!! Now I need to solve an idle problem. It will not idle down to low idle. You can pull the rod forward that goes from the governor to the carb and it will idle down. As soon as you give it throttle and then throttle back, it will not idle all the way down again. I shortened the rod between the carb and governor, but that did not help. The governor works fine and does not surge, but the engine does not speed up much until you are at about half way of the throttle. Could this be caused by weak or broken springs in the governor???
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|