Farmall & IHC Tractors Discussion Board |
Re: Re: 41A Cutout question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave on July 09, 2001 at 10:19:26 from (138.29.169.43):
In Reply to: Re: 41A Cutout question posted by Ralph on July 09, 2001 at 10:03:53:
The 20 volts does drop under load: when I put the 12 volt battery in series it drops to about 13 volts with 7 amps of charge. I'd like to go a 12 volt system, but I need the cutout to do it right. If I can't find the cutout, I'll buy the cheap battery and go back to 6 volts (I went to 12 because I had a good used 12volt batt laying around, plus they are cheap, and start good). Right now I have the 6 volt cutout rigged up with the points far apart and a 25 ohm resistor in series with the fine wire coil to make it close at 12 volts instead of six. It closes slowly, though. I wonder if anyone has had any luck with a big 10-amp diode? Tks, Dave
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|