Farmall & IHC Tractors Discussion Board |
Re: Re: F-12 Belt Pulley
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Kerr on January 13, 2002 at 10:14:08 from (152.163.206.211):
In Reply to: Re: F-12 Belt Pulley posted by Brian on January 13, 2002 at 06:27:49:
My F-12 does the same thing, and I also use my foot, carefully!, to slow it down if in a hurry. I usually just throttle it down before stopping so the wait isn't long. I think the pulley was standard, but I did find a shaft cover so it could be taken off if not needed or would be in the way of some equipment. On the 10-20s the pully was to be removed when doing field work so the weight of the pulley wouldn't brindell the bearings, those pulleys are heavy.10-20s had a cover bolted right on to the top of the gear case so it was handy. Those pullys could be turned off though when not needed. Since the F-12 pulley runs all the time it may be easier on the bearings if going over rough ground.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|