Farmall & IHC Tractors Discussion Board |
HELP! Bolster bearing, which way?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John S-B on March 11, 2007 at 13:13:26 from (64.12.116.71):
I'm reinstalling the front bolster on the M and I don't know which side is supposed to go up on the bearing. One side is machined and flat across the whole side with a small 45 deg. bevel on the inside. the other side has the mfg. name and part no. stamped on it, and a smaller machined area. The inside edge is a large radius. It looks like that side would go down to fit the bolster but there is a ring of thinner metal around the outside edge of the bearing and it wraps around the outside edge of the second side. That metal ring sticks out a little further than the smaller machined area of the second side. The bolster has a small ridge on the area that the bearing sits on and the ring of thinner metal. Can anyone tell me for sure which side goes up? I want to get it right the first time. Thanks John S-B.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|