Farmall & IHC Tractors Discussion Board |
I Don't Know What to Say.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by A. Bohemian on April 18, 2007 at 10:27:20 from (207.170.88.58):
In Reply to: Super C govenor posted by whompuscat on April 18, 2007 at 07:35:24:
Okay, I went out and checked the governor operation on my Super C. It was much as you described: that is, with the speed control lever at full advance, the rockshaft arm went all the way back. With the throttle rod pulled all the way back toward the carb, AS PER THE MANUAL, the holes on the clevis pin did NOT line up with the hole in the rockshaft arm! The throttle rod, as adjusted, was much too long. With the speed control lever at lowest speed the rockshaft arm went forward (away from the carb) as it is supposed to. Then with the throttle rod moved all the way forward, the pin and holes DID match. Perfectly. I don't know what to tell you. Mine is a good running tractor that pulls very, very well, idles smoothly, and except for normal wear on the linkages, etc., shows no signs of governor problems. I stress that it pulls VERY well. I don't like to use it for heavy work, but this spring the Ford 2600 was out of commission for a while, so I had to use the Super C to plow up my orchard expansion. The C pulled the two-bottom sulky plow at full depth through tight soil that had not been tilled in eleven years with NO problems. (While I was messing with the throttle rod I moved the fuel line to get a good look and the damn thing sprung a leak. It is very old and brittle and could well have been the original. Off to the Case dealer.)
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|