Farmall & IHC Tractors Discussion Board |
Re: M pulling 3 bottom 16 inch?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by billonthefarm on April 20, 2007 at 05:42:17 from (204.42.16.182):
In Reply to: Re: M pulling 3 bottom 16 inch? posted by Hugh MacKay on April 20, 2007 at 03:03:21:
Well Hugh, those places do exist. In my area there is alot of gumbo. In the fall a 720 or 730 diesel will have a decent load pulling 3-14 8 inches deep in second gear. I have seen the super M's with 3-14 have to run in low and then struggle. When we used to moldboard everything a 1066 and a 5-16 plow was a good match in low 3rd sometimes in t/a. And I will tell you something else, if you have conditions like this you will know how to set a plow and properly weight and tune your tractor or it just will not work. Back when IH was getting ready to introduce the auto reset plows they brought one up from the Canton plant into our area to try it out. Just going across the field the draft would overcome the springs and the bottoms would reset. They were quite suprised. Ground like this will humble the best of tractor and plowman! bill
Replies:
Home
| Forums
Today's Featured Article -
Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|