Farmall & IHC Tractors Discussion Board |
To all 300-350-400 FastHitch owners
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Agpilot on April 22, 2007 at 01:36:02 from (206.146.78.170):
Hello: In another post I asked about the Farmall 350 hydraulic system because I am going to check out another tractor. I may have to add IHC hyd fluid before starting it. After starting it I want to test the hydraulic system by using the Fasthitch system, with the standard flat drawbar inserted, to raise the rear of the tractor. So my question is how well do other fasthitchs raise the rear of your tractor. The big question is: How fast do you have to run your engine to get it to lift both rear wheels off the ground? My prime interest is the 350 models but I would think most all of the 300-350-400-450 would be similar. Having fluid filled rear tires and wheel weights would also add to the amount of pressure needed. (rowcrop models) No, I'll not have access to a pressure tester. Using the hitch will also test the hitch itself and give a reasonable idea how well his hyd system works. ( Yes I'll Use Standard safety precautions before testing) Thanks Agpilot
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|