Farmall & IHC Tractors Discussion Board |
Reply to Allan. A role model for many.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Huss on May 22, 2007 at 05:16:53 from (58.178.118.50):
In Reply to: Re: URGENT HELP PLEASE, IH 756 posted by Allan In NE on May 22, 2007 at 03:44:18:
Hi Allen, As always you take the time to help other, You are a role model for many. Thank you for your reply. I havnt checked the pressure as I had replaced the 12gpm pump with a new 17gpm pump and assumed it was fine. I guess not will look at that tomorrw. Will also do the same with the regulator. It is actually lifting fine. The problem is that if i want to raise the position lever any more it is not just a matter of pulling it up a inch or two. I have to lower the raise position lever all the way back down and start to pull it up again. This is the problem. Thank you again Huss
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|