Farmall & IHC Tractors Discussion Board |
Re: At what RPM is peak efficiency (torque) for M?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by agpilot on May 27, 2007 at 10:58:34 from (206.146.78.170):
In Reply to: Re: At what RPM is peak efficiency (torque) for M? posted by CNKS on May 27, 2007 at 08:33:45:
Hello CNKS: With all due respect, I don't remember reading anything where IHC stated that the M engine was designed for full throttle. As a backup to this I'll point out that rated PTO RPM of 540 is obtained well below max engine RPM. Why did they not use full engine RPM power to the PTO? I can't recall all the books or manuals I've read years ago but I'll stay with my impression that the M and most other 4 cylinder Farmalls were designed with a fairly Flat torque curve from half to full RPM. Most non-turbo engines have a peak in torque about 70 percent max RPM. An earlier 425hp Corvette I had peaked torque at 5100 but Redline was 6400. I've read many of your posts and you have a very good knowledge of Farmall but I'll hold to staying with saying the M has a very usefull and relative flat output power from above half RPM to almost full RPM. Another place I can see flat output in most 4 cylinder classic Farmalls is in a tractor pull. They hang tuff untill engine RPM goes below about half. Then they fade faster. Most aircraft piston engines have published torque curves and fuel used vs power output etc for all comercial pilots to use. Pilots have to know this to plan a safe flight. If only we had this type of info on Farmalls like I've seen for low RPM non-turbo piston aircraft engines... Hopeing your having a great weekend... agpilot
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|