Farmall & IHC Tractors Discussion Board |
Re: HELLPP!!! 460 U power steering
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Butch WI on May 27, 2007 at 17:52:42 from (66.82.9.104):
In Reply to: Re: HELLPP!!! 460 U power steering posted by CNKS on May 27, 2007 at 14:32:25:
CNKS, There is a small gear case at the bottom of the steering shaft that contains(ed) oil. I was trying to remove the steering wheel by turning two bolts into the threaded holes on the steering wheel. I cleaned out the holes and proceeded to tighten on them(They should force the steering wheel shaft away from the steering wheel) If I am not mistaken it is a conical shaped splined shaft on the steering shaft which mates up to the steering wheel. WWhen I had what I thought was plenty of preesure on those two bolts I started to hit them with the hammer to try to jolt them free. I understand damage occurs with excessive force, so I didn't use any (so I thought) A couple minues later I had this BLACK stream running down the clutch housing. I had recently replaced all hydraulic oil. As I removed this entire steering system I figured out where the hyd system connects to the steering. But there still is the gearcase that needs lube. What type of puller should I use? I think a puller will just break apart the plastic steering wheel, unless my vision of a puller is not correct. I'll try to post a pic later! Butch
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|