Farmall & IHC Tractors Discussion Board |
Re: a little bit disappointed....
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Justin on March 08, 2002 at 19:06:04 from (209.23.152.143):
In Reply to: a little bit disappointed.... posted by Steven@nd on March 08, 2002 at 17:00:18:
You could have gone with the sealded power (federal mogul) manufacture pistons that are identical to the H firecraters and cheaper. But since you are going to use a kero/distillate head the firecraters and other High altitude, high compression gasoline pistons won't help much. I would have suggested using a high altitude piston for the fuel type of head you are using (5,000' kero pistons are 8,000' gas pistons), and you would have realized more power. If you are going to use a 300/350 LP head, you will probably have to check to make sure that the piston has clearance with the top of the combustion chamber. A lot of things to be considered. As far as prices: pistons and sleeves (Sealed power Firecraters $350/set) (high altitude kero 3 3/8 bore $275), Bearings $90 for a set of 0.030 rods and mains, Gasket set ~ $85-90, Valves: depends on your cylinder head (probably better check to make sure you recieved the correct valves with the set)..
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|