Farmall & IHC Tractors Discussion Board |
Re: '50 H Front End Fix-Another Question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmall_Man on April 09, 2002 at 17:02:25 from (32.97.110.142):
In Reply to: '50 H Front End Fix-Another Question posted by Krey in Indiana on April 09, 2002 at 04:10:03:
Krey, I ordered the entire kit from Carter & Gruenwald for $105. This does not contain the bushing and seal for where the worm gear shaft comes thru at the top. It does contain everything else needed. To remove the top bushing and seal and the bushing for the worm shaft, I used a deep well socket that would just fit inside the hole and tapped it gently with a hammer. It took less than 5 minutes for each bushing to come out. Tapping down from the top on the bushing caused the grease seal to come out with the bushing. Now to take the grease seal out for the worm shaft, I just used a punch and pretty much ripped that one up getting it out. It really didn't matter as I was going to replace it anyway. The bottom bushing was a bit more difficult, but didn't take too much time. I was able to get a long screwdriver down thru hole from the top and set it against the thrust bearing. After some tapping, first on one side then the other, it all came out. It probably didn't take more that 30 minutes to get all three bushings out. All of this was made much easier due to the fact that I had the bolster off the tractor and laying down where I could get to it. Hope this helps. FM
Follow Ups:
Home
| Forums
Today's Featured Article -
A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|