Farmall & IHC Tractors Discussion Board |
Re: super c ignition coil question--please help
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by WEK on April 18, 2002 at 08:22:50 from (205.188.196.38):
In Reply to: super c ignition coil question--please help posted by john on April 17, 2002 at 17:11:50:
John, without meaning to sound cynical, shouldn't you have asked your question before you hooked up your coil? At any rate, your coil has (or should have)the two terminals plus a tower in the center. If your tractor has the battery NEG post connected to the starter and the POS post to ground, then the terminal on your coil marked POS should be connected to your distributor. The thick cable that comes out of the coil center tower (known as the secondary or high-tension cable) of course, goes to the center tower of your distributor. If your coil is heating up excessively it is possible that you may need a ballast resistor (you should have received an instruction sheet with your new coil)or that all the connections at the two terminals and the high tension boots are not clean and tight, thus increasing the amount of resistance in the circuit (resistance causes heat).Hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|