Farmall & IHC Tractors Discussion Board |
Flaw with unfreezing stuck engine with hydraulics (Part II)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan Kelley on April 23, 2002 at 14:38:13 from (63.104.174.146):
Here's a thought. Instead of hooking up a hydraulic hose to the spark-plug hole, what if I hooked up a grease fitting? Spark plugs are threaded with NPT threads, are they not? Just get a short piece of iron pipe and a pipe cap. Drill a hole in the pipe cap and thread it for the grease fitting. Put the cap on the pipe, the grease fitting in the cap and the pipe in the spark plug hole. I could use my grease gun to force the piston out slowly. This way, I could take out the crank, and do a cylinder at a time. I should not end up with bent rods or flying pistons. The piston/rod may pop a bit coming out, but grease is not very compressible. I could then scrape out the grease, stuff most of it back into my grease gun and do the next cylinder. It might be a bit messy, but who in the tractor world doesn't like a little bit of a mess from time to time? Am I missing something?
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|