Farmall & IHC Tractors Discussion Board |
Re: Farmall C Governor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by PeteinNY on May 14, 2002 at 16:39:24 from (66.24.154.149):
In Reply to: Farmall C Governor posted by Steve Mason on May 14, 2002 at 06:48:12:
Steve, It sounds like you may be in need of a complete rebuild as geoff mentioned, but Scotty nailed your hunting problem on the head. If adjusting that slotted head screw doesn't make any or much difference, unscrew it all the way and take the spring out and check it's condition. Ours was broken almost all the way through about 2/3 of the way down, this area seemed to have gathered some moisture over the years and corroded the spring, a new spring made a world of difference. Also if you replace the main bushing, be aware that after you press it in, the inside diameter will shrink some, and may require some honing. We used a brake cylinder hone and about 3 new sets of stones before we got it right. Be sure to stuff a rag in the gap by the gear to keep the brass dust out of the timing cover. If you have access to a reamer, they will work, but it may be easy to go too far too quick, that's why I prefer the brake cylinder hone, even though it's more time consuming (couple hours of honing!) Good luck! It's worth it though, you can just about knock yourself off the seat with ours now when that governor comes up! Pete
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|