Farmall & IHC Tractors Discussion Board |
Re: HELP! I need to unstick my 300U adjustable axle!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on June 04, 2002 at 01:55:27 from (216.208.58.115):
In Reply to: HELP! I need to unstick my 300U adjustable axle! posted by joe on June 03, 2002 at 20:01:25:
There may not be any method thats not extreem. I had to take axle assembly from under 130 hang it end ways from ceiling with wheels on. We then heated the outside tube with two torches. Using a block of wood on spindle shaft we used a 8 lb hammer. It wasn't until we had that entire outside tube red that it came free. We had so much heat on that, we started to get nervous that we might burn building down. What came out from between the tubes was rust just like sand. At time we wondered if we may have taken strengh out of tubing. Well my friend it is back on tractor and that was 11 years ago.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|