Farmall & IHC Tractors Discussion Board |
Re: H Lube system question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmer Bob on July 02, 2002 at 21:08:52 from (66.152.73.237):
In Reply to: H Lube system question posted by Christopher Zahrt on July 02, 2002 at 15:42:19:
Christopher, Don't go to that length of trouble until you have done the following. First, crank the engine over with the starter (Switch off) until you see some oil pressure building on the guage. Remove the valve cover and verify that oil is getting into the rocker arm assembly. Carefully remove the breather tube from the front of the head and the housing atop the governor. Check to make sure that tube is not clogged with old gunk. I use a length of #12 copper wire to push through these to clean out any sludge. Blow it out with compressed air. Reassemble everything and you should be good to go.//FB
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|