Farmall & IHC Tractors Discussion Board |
I Love my M but..................
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by On2Wheels on July 05, 2002 at 04:48:09 from (24.48.104.71):
I was replacing the seal for the main drive shaft that comes off the transmission case. Got the seal housing off ok, but when I went to remove the piece from the main shaft on the transmission that connects to the engine side shaft (the one that goes into the clutch)when pulling it off the shaft it was long enough to hit the engine side shaft. Well to make a long story short I ended up removing the entire clucth assembly so as to make enough room. The engineers dropped the ball on this one. That area could have been 1 inch longer to accomadate the removal of the shaft from the transmission. If there is a trick to this I certainly could not figure it out. Now an H dosen't have this problem as it is long enough in this area.
Follow Ups:
Home
| Forums
Today's Featured Article -
A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|