Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Wet Sleeves or Dry Sleeves
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Todd Frampton on December 18, 2002 at 20:35:57 from (209.195.174.80):
In Reply to: Re: Re: Wet Sleeves or Dry Sleeves posted by Big Jim on December 18, 2002 at 14:32:25:
Thanks for comments. I had to machine a disc (as you guys mention) on my lathe and use the middle stud from a coil spring compressor to pull the other three sleeves. I then plugged the block heater in and put the sleeves in a freezer for a while. Then coated with diesel fuel and they went in with not too much tapping. The connecting rod on #1 cyl was bent and when I pulled out (after discovering something was wrong) the sleeve came out too (that cyl was the one that had problems, I had to smooth out block wall a little with sand paper). Obtained reconditioned rod and put back together, however sleeve fit was probably looser than should be, but so far no problems. I didn't have pressure gage to determine force to install sleeves. Sounds as though the dry sleeve engines rack up a lot of hours just as the wet sleeve engines. D188 runs strong.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|