Farmall & IHC Tractors Discussion Board |
stuck tie rods
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on December 21, 2002 at 21:48:45 from (64.252.114.245):
Hi, I have an IH 574 and am changing the front wheel spacing. I am having one helluva time getting any movement on the tie rods--have tried weeks of penetrating oil and heat from a MAPP gas torch. I completely removed the tie rods from the tractor and am looking for suggestions on how to free up them up. The boots are shot on the tie rods--I plan to replace them if I can find them, is it too late to save the joints? They move ok but are a bit sticky. Also, the spindle housing on one side broke clean off while I was trying to get the knuckle off, not sure how that happened as I was tapping the knuckle and was nowhere near the spindle housing when it broke. Any suggesions on welding this? Thanks for any help! Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|