Farmall & IHC Tractors Discussion Board |
Using Felt Seals and gaskets
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brian on January 05, 2003 at 16:06:47 from (24.114.185.3):
I'm starting to put the seals back in the A, and now for a couple more questions: is there any prep work required for the felt type seals ? Such as soaking them in oil, or maybe just putting some around the edge ? For the paper/card board type, same question, do I soak them at all ? What about using a thin layer of gasket maker (high temp orange stuff that comes in a tube) on both surfaces ? Final question, I have a complete gasket set for rebuilding the motor, it's from Federal Mogul. There is a round felt seal, maybe 3/4 to 1" dia, with maybe a 3/8 hole in the centre, what the heck is that for ? Thanks again, Brian Toronto.
Follow Ups:
Home
| Forums
Today's Featured Article -
A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|