|
Farmall & IHC Tractors Discussion Board |
Re: '43 M hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steven@nd on January 18, 2003 at 16:47:55 from (12.23.184.100):
In Reply to: '43 M hydraulics posted by IowayBoy on January 18, 2003 at 16:05:58:
If your getting hydraulic oil in the crankcase then the seals in the pump are blown. I'm not sure if parts are available, or where you can get them either. To remove the pump there should be 4 bolts into the timing cover. Be sure to crank the engine over to compression stroke on #1 cylinder - a couple of ways to do it. Take out #1 spark plug and crank over until air comes out, then align the notch on the crank pulley with the pointer on the cover. OR you can just take of the distributor cap and turn until the rotor lines up with #1 spark plug wire. Be sure to put it back together the same way. A shop manual will help, either the IH version or the I&T have some helpful hints. Might I make a suggestion for you loader, a PTO driven pump. Of course it won't be live, but will develop better GPM and pressure. Check out northerntool.com for PTO pumps. We have good luck with them on our tractors.
Follow Ups:
Home
| Forums
Today's Featured Article -
A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
