Farmall & IHC Tractors Discussion Board |
Re: super a pto diassembly ?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gary on February 14, 2003 at 19:09:44 from (64.12.103.24):
In Reply to: super a pto diassembly ? posted by sjh on February 14, 2003 at 09:35:43:
Yes. kinda. I've got two of them. The PTO by itself does not have shims. Just stick it on. There should have been some shims with the two pieces if they came off the same tractor. If so, use them and you will probably be right, or close toit. You can go from there, Don't try to get all of the slack out. It WILL overheat. If you didn't get them as a pair, make certain the drive gear for the belt pulley attachment is compatible with the driven gear on the pulley attachment. I ran into this once. There is a bushing on the belt pulley output shaft that rides in theseal. The seal does not seal against the shaft itself. When you don't have your flat belt pulley on, but are using your PTO, thereis a piece of pipe that takes the place of the pulley to hold the bushing in the seal. Holler if you need anything further.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|