Farmall & IHC Tractors Discussion Board |
Re: Hammer mill Farmall H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on March 18, 2003 at 06:15:32 from (67.251.189.88):
In Reply to: Hammer mill Farmall H posted by Scott in MO on March 17, 2003 at 19:49:33:
A hammermill is rated by the width of the hammer rotor. They came in inches for width. An H will handle anything up to 9in or so 6 was very common and a traveling table is the best then the next problem is how high in the air you are blowing this determines a lot of the capicity. Ours was a MONTGOMERY WARD and we blew about 18 ft. The B would gring almost as fast as the M as the pulleys were different sizes. Do you need one? They can still be found here in IOWA but are getting hard to find as the GRINDER MIXERS are popular and they are lots of smaller ones of these around.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|