Farmall & IHC Tractors Discussion Board |
Farmall H Overbore Sleeves 3/3/8 to 3/7/16?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andrew from Australia on March 19, 2003 at 21:22:27 from (203.108.4.132):
Hello, I am doing up a Farmall H standard. Am I right in thinking that the "overbore" sleeves 3 7/16" will fit straight in a standard H engine with out modification to the block? This would upgrade it from an H to a Super H? I know this is a question that probably comes up all the time and I'm sorry to repeat. I couldn't see anything in my quick look in the archives. Thank you for your response. PS The engine is a kero job (assume low comp head)and I was going to go for some flat top pistons to suit. Sound OK to you guys? I paid A$100 (US$60) for it seized and it's cleaned up pretty well so far. Should be a fun machine to use. Regards Andrew Sydney, Australia
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|