Farmall & IHC Tractors Discussion Board |
Re: Need help on brakes and pinion on 400
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Aces on April 03, 2003 at 19:15:19 from (205.187.80.72):
In Reply to: Need help on brakes and pinion on 400 posted by Carp on April 03, 2003 at 17:00:45:
You can change the out side Bearing without moving bull gear but not the in side and it will come out with the brake shaft after the brake is off there is 2 plates the first one looks about 1/2" thick but it goes in side the other one to hold the seal and no screws i it it should come off with a little screwdriver ply if you need to replace the inside brg you will have to remove the axel and movr the bull gear back a little and off to the other for the pinion housing to pas the bull gear
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|