Farmall & IHC Tractors Discussion Board |
Re: 4-Position Switch to Charging Problems
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Fred KS on May 15, 2003 at 18:30:50 from (64.39.205.3):
In Reply to: 4-Position Switch to Charging Problems posted by Farmall Don on May 15, 2003 at 18:09:50:
Don, Sounds like you will have to polarize your electrical system. Anytime you disconnect the leads from the generator or regulator you will have to polarize them to get the juice flowing again. This is done prior to starting the tractor. If you have a POSITIVE ground system, momentarily connect a jumper wire between the "BAT" terminal on the regulator and the "A" terminal on the generator. Do not touch the "F" terminal on the generator or you could damage your regulator. Hope this helps. Fred KS
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|