Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Super H charging question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on July 07, 2003 at 06:50:31 from (165.170.128.66):
In Reply to: Re: Re: Super H charging question posted by ellson on July 07, 2003 at 05:14:15:
A –4 amp reading with the ignition on and the motor stopped says your ammeter is hooked up right and is working correctly with the motor off. However the ammeter vibrating between 0 to –20 with a voltage reading of 9.5 –10 is puzzling…..the ammeter indication is battery is discharging, but the voltage reading says it’s charging. Presuming your voltmeter is accurate (a safe assumption based on your “engine stopped” voltage reading) then the battery IS being charged with the motor running. That means your charging system is basically healthy. But it also means ammeter reading is somehow outta whack on the charge side. A possible cause is charging circuit wire running too close to the ammeter inside the switch box. If not that then suggest swapping the ammeter for a known good one and see what it reads.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|