Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Clutch Disk - Backwards?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Theman on July 28, 2003 at 13:41:43 from (12.19.86.5):
In Reply to: Re: Re: Clutch Disk - Backwards? posted by NewGuy on July 28, 2003 at 12:25:41:
It is hard to imagine that the six bolts would be long enough to start in the flywheel with the disk in backward. But, if the pressure plate clamps the clutch disk up tight before the six bolts seat the plate assembly to the flywheel, check the disk orientation. The clutch disk is, in fact, side specific. The disk should turn easily before you remove the three bolts compressing the pressure plate springs. The three bolts I was referring to are on the fingers themselves. These are the fine threaded ones with the jam nuts. I'm guessing they're about 3/8" dia. Back the jam nuts out to the bolt heads and turn the bolts in toward the pressure plate (clockwise). You will see the finger begin to swing back toward the thrust bearing. It is important that you adjust all three fingers to the same clearance.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|