Farmall & IHC Tractors Discussion Board |
Re: H - Crank doesn't line up?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by justin on August 14, 2003 at 21:23:40 from (216.188.198.180):
In Reply to: H - Crank doesn't line up? posted by Brad on August 14, 2003 at 19:05:03:
This is one of those problems where you can see why IH updated a part. Your tractor more than likely has the early engine mounts that are like those used on a car, two plates with rubber between to absorb vibration. Over time these will start to lose their srength, and the engine will begin to sag between the frame rails. If this is the case, you have two options: 1. replace the frame rails and engine mounts with those that are set up for the cast iron mounts. (framerails for the older mounts wont work with the newer mounts) 2. Take the mounts out, and have a professional welder remove the rubber, and install a block or plate to make the mounts sturdy. I have had this done to preserve the outward aspects of my 2 39 Hs, and also to allow me to start them both, as they are crank starts and I have experienced this problem.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|