Farmall & IHC Tractors Discussion Board |
Re: Position of thermostat
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by t4mike on November 24, 2003 at 07:26:24 from (66.11.101.99):
In Reply to: Position of thermostat posted by Clete on November 20, 2003 at 08:49:07:
again i say the thermostat has tobe held tight. i just went out and looked a ih 135 engine thermo housing. the stat is held tight by the snap ring. the stat is placed into the larger bore and seated to the smaller bore of the stat housing. then the retainer ring is snapped into the groove that is at the surface of the stat flange. problem for me before was that the stat flanges are not as thick as were made years ago, thus mine had a few thousands up/down movement. the engine would not warm up to operating temp. i shimmed the stat tight between the stat flange and snap ring with a aluminum ring i made from some coil stock i had. is your groove rusted up that your not installing the ring where it should go? do you have a smaller bore for the stat to seat to? do you have a aftermarket stat housing? no way should it move a inch. i also had this same problem with a chevy truck engine, (loose stat in housing). hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|