Farmall & IHC Tractors Discussion Board |
Re: Removing front pulley, Farmall A
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RayP(MI) on November 25, 2003 at 16:45:36 from (216.46.194.142):
In Reply to: Removing front pulley, Farmall A posted by Mark on November 23, 2003 at 14:44:46:
Hope this isn't too late! Had the same problem on my Farmall 200. Finally resorted to drilling two holes in the pulley inside the shoulder of the V, and outside the shoulder (back side) of the hub. Then a deep socket placed on the end of the crankshaft, a steel plate with holes appropriately placed to match the two I just drilled in the pulley. Put a couple bolts through the plate and pulley, and nuts on the back of pulley. Had to grind the flats on one side of the nuts to fit. Anyway, that made a custom puller that worked superbly. Used a air impact wrench - couple bumps on each bolt alternately until it walked the pulley off. Worked fine - I'm saving that setup! (Think the bolts were 5/16")
Follow Ups:
Home
| Forums
Today's Featured Article -
A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|