Farmall & IHC Tractors Discussion Board |
Re: seized MD
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by aaron on December 12, 2003 at 06:45:47 from (130.20.144.81):
In Reply to: seized MD posted by scott on December 11, 2003 at 20:20:14:
I have rebuilt an M engine where all 4 pistons were froze as well. Everyone has an opinion. I have a method that worked for me. I put some liquid wrench on top of the pistons and then unbolted the oil pan and removed all the rod caps. Use a rubber dead blow hammer and a 1" or larger wooden dowel. Place the dowel underneath the piston, on the wrist pin joint(So you do not knock the top of the piston off) and hammer like a mother fuc### for about two hours a piece and they they come right out the top! Yes I know that sounds like work, it is... BUT, it works. Get this, I even put a bottle jack underneath one of the pistons to push it out the top, nope. The entire tractor lifted off the ground. Remember all that is stuck is those little rings. Just pound with all your might and they will come right out the top. You'll get them out. -Aaron
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|