Farmall & IHC Tractors Discussion Board |
Re: IH 8 ft. wheel disc
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on January 19, 2004 at 13:43:18 from (64.228.11.64):
In Reply to: IH 8 ft. wheel disc posted by Ron Shull on January 18, 2004 at 16:16:08:
Ron: I think I have a clear picture on most of what you are looking for. Not sure on that lifting pipe to the hitch, can you explain a bit more? The rod to support hoses can be fabricated quite easily. On disk scrapers, probably another older disk. I have one here but not IH so scrapers could be same or different. A lot of these scrapers are the same. Mine is currently under 4 feet of snow. You are welcome if you wish to wait until snow is gone. No charge just shipping. The coupler you are speaking of, is that the break away coupler, designed to disconnect should the disk come unhooked. I would look to salvage yards on that. Those guys seem to be more interested in tractors than implements.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|