Farmall & IHC Tractors Discussion Board |
Re: Father-in-Law's 154 Low-Boy... Pease help.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Esev on April 12, 2004 at 18:48:13 from (24.54.43.123):
In Reply to: Father-in-Law's 154 Low-Boy... Pease help. posted by ALAN on April 12, 2004 at 17:58:30:
Hey Alan, I am no pro here, and I am in a similar situation on my recently aquired 1970 154 Lo-boy. I was lucky and got a photo copied manual with my tractor when I got it. I also got a lot of information from the Cub web sight (www.cleancomputes.com/cub/index.html) including parts manual pages. I was able to remove my clutch without moving the engine forward the two inches (as manual states). I un-did the coupling from the motor and was able to slide the main shaft far enough ahead to get it out of the clutch disc. I was able to get a new disc and pilot bushing from the local I.H. dealer for around $50. My throw out, and pressure plate were OK, but I wouldn't be suprised if they are still available through I.H. too. My dilema was the main shaft had a serious vibration when engaged, indicating pilot bushing problems. When I took it apart I found that there was no pilot bushing present !! Now that I have begun putting it back together, I have found that with the pilot, disc, and pressure plate installed the shaft does not line up with the motor coupling very well (by more than a 1/2 inch), and I am not sure why ??? I started looking for signs of a bent frame, or egg shaped trans axel mounts, but don't see any problems. Now I am guessing that this may be why it ate the pilot bushing (or why it was intentionally left out). What am I missing here, any comments please ????? Thanks, Esev
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|