Farmall & IHC Tractors Discussion Board |
F20 Front Wheel Barings
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by grg's F-20 on April 19, 2004 at 10:40:24 from (209.94.161.43):
On Saturday everything was going along pretty good,on getting front end jacked up and supported,so wheels can be pulled for painting. Had one pulled off in 5 minutes then came the other wheel had all washers & nuts off and bearing would not move on shaft. Tried big hammer, 2x4, chisel ,torch, then grinder to cut inner race edge so when bearing cage was dismantled rollers could be pulled out one by one. Then got wheel off over inner race and pounded race off shaft which came hard. Tried bearing from other side and slides on like it should. Anyone else have this problem? Came from Factory like this -no signs of every being apart - one bend on lock washer only.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|