Farmall & IHC Tractors Discussion Board |
Re: 460U gas line, throttle spring, air precleaner
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RPM on May 08, 2004 at 09:42:33 from (209.152.115.185):
In Reply to: 460U gas line, throttle spring, air precleaner posted by doug stockman on May 08, 2004 at 03:25:28:
The gas line, get a steel brake line at any auto parts store, cut the flares and remove the nuts, get 2 special nuts at CNH dealer, part 222-503, these have a groove that breaks off end when you install the line and into original fittings for the depth by pushing line into carb fitting and same for fuel trap under tank, this will crimp itself onto line, then you can remove line again later and ends should be reusable. The linkage for throttle is going to be tougher, these parts no longer available except spring and ball end joint, junk yard only hope. 460-560 never had any paper air filter of any kind when built either on top or the main lower filter that was oil bath.
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|