Farmall & IHC Tractors Discussion Board |
Re: Farmall H hand crank?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Roger WI on September 08, 2004 at 20:29:35 from (69.58.150.217):
In Reply to: Farmall H hand crank? posted by BobinOhio on September 07, 2004 at 17:23:55:
Bob, I just had mine all apart on my H about a month ago. The whole crank assembly can be removed without taking the bolster off the tractor. There is a pin (the spring side) under the sleeve over the part that engages into the crankshaft. That sleeve can be really rusted to to that big shaft after years of mud and radiator leaks. I had to pound on mine a lot to get it to slide back to expose the pin. Once you get that pin out, there is a cotter pin in the shaft that comes out the front of the tractor. You need to remove that so that shaft can be pushed out making room for the big shaft to slide out. Of coarse you have to remove the bottom sheetmetal cover (if there is one there) to get at all this mechanism. Once you get it apart you can either try to grind out the slots or get a different one at a tractor salvage yard (I doubt there are new ones available). You probably should replace the pin connecting the two shafts as mine was really worn. I just cut a bolt the same length as the existing pin. I hope I discribed it OK. Roger
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|