Farmall & IHC Tractors Discussion Board |
Re: Coil Hot...Farmall 400
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Allan in NE on September 23, 2004 at 16:53:09 from (148.78.243.25):
In Reply to: Re: Coil Hot...Farmall 400 posted by MagMan on September 23, 2004 at 16:37:35:
Jon, Yes, that is exactly what I mean. If she is borderline, you let off the starter, the engine is still spinning just a bit, and now all of a sudden we have ignition at the points because we don't have that starter a hoggin' all the juice. A lot of automotive applications that used points and 12-volt systems would "bypass" that ignition resistor during cranking and feed a full 12 volts to the coil. If you have ever noticed a GM starter solenoid with the extra little connector lug, this is what it was used for in years gone by. It would jump 12 volts directly to the coil primary circuit. Same way with the Ford starter relays. Chrysler products grabbed the voltage directly from the starter’s electrical connection block. No, I'm not good; I'm old. :>) Hope ya get 'er goin', Allan
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|