Farmall & IHC Tractors Discussion Board |
Re: 3-Point hitch . . . or not ?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ron in Nebr on October 22, 2004 at 22:10:34 from (65.172.143.197):
In Reply to: 3-Point hitch . . . or not ? posted by Eddie Kramer on October 22, 2004 at 15:13:45:
Our 484 has a 3-point. To add to what the other post says, the lower links are the heavy iron bars with pivot balls in both ends of them that are on either side of the rear of the tractor, about the same height as the drawbar. These arms are free to swing back and forth and will have a chain attachment to the center of the tractor to limit how far out they can swing. There should be a linkage going up from both of these arms to two shorter arms that move up and down via the tractor's hydraulics, which will be operated by a lever just to the right of the seat, in front of the pto lever. The top link, whether or not it's there, will have a mounting bracket in the center roughly two feet above the drawbar where a round pin about 3/4" diameter and about 5" long goes through the heim on the adjustable upper link. If you look through the photo pages on this site there's probably a picture of a 3 point there.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|