Farmall & IHC Tractors Discussion Board |
Re: W-30 related to anything else??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike Androvich on December 09, 2004 at 14:58:12 from (24.50.141.220):
In Reply to: Re: W-30 related to anything else?? posted by novice on December 09, 2004 at 12:20:44:
Taking a crank out of a W-30 is an major job. These engines have two large ball bearing for mains, and you don't just take out the crank like other shell bearing engines. You have to pull the flywheel off the crank and then pull the crank out of the block and then pull the bearing off the crank. Not an overnight thing! I bet that all you are going to have to do is adjust your rod bearings. That is generally all that has gone wrong unless the engine has run some significant time without oil. Especially since you say it only knocks some under load. Should be a very easy fix. Take a shim out one at a time alternating sides of the bearing cap until it's too tight to turn after tightening the cap; then add one more shim back and you should be all set.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|