Farmall & IHC Tractors Discussion Board |
Re: SPLIT MANIFOLD
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by n8terry on January 17, 2005 at 09:56:23 from (67.250.216.200):
In Reply to: SPLIT MANIFOLD posted by FRANK on January 17, 2005 at 07:54:01:
I just had a manifold split, but it was on a 6 cyl tractor. I am sure the sound is quite different than what your 4 cyl will sound like. You should take the manifold to an experienced welder and have him test weld to see how well the manifold will accept the weld. I was told that nickle rod is the best. I cut the hole using a circular hole blade. The hole was about 1/16 larger than the black pipe I used for the outlet. The extra 1/16 allowed the welder to penetrate better along the edge. The saw blade became dull before I got through the manifold, so I poured valve grinding compound into the saw groove, continued cutting very slowly so compound wouldn't be thrown from the groove. I had the hole cut in about 20 minutes.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|