Farmall & IHC Tractors Discussion Board |
Re: Farmall 706 310d sleeves
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Trent R. Young on March 02, 2005 at 17:00:12 from (64.12.117.13):
In Reply to: Re: Farmall 706 310d sleeves posted by El Toro on March 02, 2005 at 14:41:24:
I didn't get your last message before we tried it. I ended up using a peice of 5/8x1in bar stock for the part that contacts the sleeve, it had to be cut pretty close not much clearance there. i was able to turn it alittle to contact the two ears of the sleeve not noched. used 1/2 in threaded rod a hand full of 2x4s and a piece of 1in flat stock on top of the wood. they were a little tight but came out pretty easy with the puller. Luckily my dad and i do a lot of fabricating and mechanical work so once we got started it wasn't to hard to figure out the rest.and we had all of the stuff we needed. the sleeves had very very very slight bit of pitting on the sleeve you can hardly even feel it with you finger. I'm going to have a guy from the local ih dealer look at them when i pick up my injectors from being rebuilt. Any other helpful hints of the rebuild to starting after all to gether would help. adjusting the valves int. .010 ex. .012warm can i set them a hair tight going back together cold so maybe i won't have to recheck them. its a pain to take the gas tank back off if you know what i mean. thanks again for all your help.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|